Инструкции Пользователя для Biketronics BT1005X Fairing and Wiring Kit

This procedure should not be necessary with new modules. All new modules 

come pre-programmed (default is 3). We recommend testing the stock 

settings before changing the AVC. To setup the AVC, please note the following:

t AVC information WILL NOT display on radio face! If your radio face changes 

at any point, turn off the bike and start over.

t The only method to verify successful AVC programming is to ride the bike 

and confirm that radio volume varies with speed.

t Count out the seconds or use a watch to determine the correct amount of 

time has passed, and then quickly go into step #2.

t There is a video of the procedure available at biketronics.com

Left handlebar control button - Push in and hold for 10 seconds, 

then release to enter programming mode.

Left handlebar control button - Push up and release between 1 

and 10 times. This step will time out after two seconds following 

the last push.

10 pushes = highest gain, 1 push = lowest gain, 0 pushes = AVC off

Allow 10 seconds for programming to reset.

Test ride bike to verify AVC program. Volume should change with 

speed.