Инструкции Пользователя для Biketronics BT1004X Fairing and Wiring Kit
12
t Be sure both radio harness and module are not plugged in.
t Strip 1/4” of insulation off wires from radio harness and gently twist ends.
t Insert wires into the appropriate slot on Biketronics module according to
chart below and module label.
t White buttons only need to be pressed to release wires.
t Note on Wired Control Output:
Kenwood and JVC radios use the blue/yellow wire. All other radios use the
3.5mm cable. It is NOT used on Kenwood or JVC radios.
Connect Radio Harness to Module
Step 6
3.5mm jack
(not used for
Kenwood or JVC)