Инструкции Пользователя для Garmin Edge® 520 Bundle

See the Important Safety and Product Information guide in the 

product box for product warnings and other important 

information.

NOTE: If you do not have this sensor, you can skip this task.
TIP: Garmin

®

 recommends you secure your bike on a stand 

while installing the sensor.

Place and hold the speed sensor on top of the wheel hub.

Pull the strap 

À

 around the wheel hub, and attach it to the 

hook 

Á

 on the sensor.

The sensor may be tilted when installed on an asymmetrical 

hub. This does not affect operation.

Rotate the wheel to check for clearance.
The sensor should not contact other parts of your bike.
NOTE: The LED flashes green for five seconds to indicate 

activity after two revolutions.

NOTE: If you do not have this sensor, you can skip this task.
TIP: Garmin recommends you secure your bike on a stand 

while installing the sensor.

Select the band size that fits your crank arm 

À

 securely.

The band you select should be the smallest one that 

stretches across the crank arm.

On the non-drive side, place and hold the flat side of the 

cadence sensor on the inside of the crank arm.

Pull the bands 

Á

 around the crank arm, and attach them to 

the hooks 

Â

 on the sensor.

Rotate the crank arm to check for clearance.
The sensor and bands should not contact any part of your 

bike or shoe.

NOTE: The LED flashes green for five seconds to indicate 

activity after two revolutions.

Take a 15 minute test ride and inspect the sensor and bands 

to ensure there is no evidence of damage.

Pairing is the process of connecting an ANT+™ wireless sensor, 

like your speed sensor or cadence sensor, with a Garmin ANT+ 

compatible device.
NOTE: The pairing instructions differ for each Garmin 

compatible device. See your owner's manual.
• Bring the Garmin compatible device within 3 m of the ANT+ 

sensor.

• Stay 10 m away from other ANT+ sensors while pairing.
After you pair the first time, your Garmin compatible device 

automatically recognizes the ANT+ sensor each time it is 

activated.

Do not use a sharp object to remove batteries.
Keep the battery away from children.
Never put batteries in mouth. If swallowed, contact your 

physician or local poison control center.
Replaceable coin cell batteries may contain perchlorate 

material. Special handling may apply. See 

Contact your local waste disposal department to properly 

recycle the batteries.

The LED flashes red to indicate a low battery level after two 

revolutions.

Locate the circular battery cover 

À

 on the back of the 

sensor.

Twist the cover counter-clockwise until the marker points to 

unlocked and the cover is loose enough to remove.

Remove the cover and the battery 

Á

.

Wait 30 seconds.

Insert the new battery with the positive side facing up.
NOTE: Do not damage or lose the O-ring gasket.

Twist the cover clockwise until the marker points to locked.
NOTE: The LED flashes red and green for a few seconds 

after battery replacement. When the LED flashes green and 

then stops flashing, the device is active and ready to send 

data.

The Garmin standard limited warranty applies to this accessory. 

3