Инструкции Пользователя для Yamaha MusicCast WX-010

Plug the power cable into the wall outlet after completing installation.

• Placing the unit too close to a CRT TV may impair the picture color or cause a buzzing noise. In this case, move the unit at 

least 20 cm (8") away from the TV. This is not an issue with LCD and plasma TVs.

• Install in a stable place, being careful of the following points:

– Do not place on top of steel or other metal plates.
– Do not cover with a cloth, etc.

You can mount the unit on the wall as follows.

A

 Install screw (commercially available) into a solid wall or wall support as shown in the illustration. Use 3.5 to 4 mm (1/8") 

diameter self-tapping screw.

B

 Hang the unit by its keyhole slot onto the protruding screw.

• Make sure the shaft of the screw is seated in the narrow part of the keyhole slot. Otherwise, the unit may fall.
• Do not mount the unit on thin plywood or on a wall with a soft surface material. Otherwise, the screw may pull out of the 

surface and the unit may fall, possibly damaging the unit or causing personal injury.

• Do not affix the unit to a wall using nails, adhesives, or unstable hardware. Long-term use and vibration may cause the unit to 

fall.

• To avoid accidents resulting from tripping over loose cables (such as a power cable), affix the cables to the wall.
• When using the brackets to mount the unit on a wall / ceiling, please use safety wire (not included) between the unit and the 

bracket to prevent the unit from falling.

• If you are not sure of a safe way to install the unit, consult a professional installer or a building contractor.
• To prevent the vibration from the sound from reaching the wall, attach the Anti-vibration pads on the four corners of the rear 

panel (

☞  P.2).

A

B