Инструкции Пользователя для MartinLogan Motion® Vision X

25

DISPLY > AUTO.DM: [AUTO DIM] This option 
configures the soundbar’s display to be on at a 
reduced brightness when a setting (such as volume 
or input) is changed. After a few seconds the display 
will turn off. Activate by pressing the enter button 
and the soundbar will respond with ‘SET’.

POWER: Enter the ‘POWER’ submenu by pressing 
the enter button. Here you may adjust how the sound-
bar turns on and off.

POWER > AUTO: This option configures the 
soundbar to turn itself off after no audio signal is 
detected for approximately 30 minutes. When the 
soundbar detects an audio signal, it will immedi-
ately turn itself on. Activate by pressing the enter 
button and the soundbar will respond with ‘SET’. 
Please note: When set to ‘AUTO’, if the soundbar 
is manually turned off (using the power button on 
the top panel or remote control), the soundbar will 
not respond to an incoming audio signal and will 
not turn on automatically. In this situation, turn the 
soundbar on using the power button on the top 
panel or remote control and the soundbar will 
resume automatic power handling.

POWER > FULL.ON: [FULL ON] This option 
configures the soundbar to remain on at all times 
until it is manually turned off using the power button 
on the top panel or remote control. Activate by 
pressing the enter button and the soundbar will 
respond with ‘SET’. 

Please note: There may be remotes that the sound-
bar cannot learn or that the soundbar can not learn 
correctly. Due to the number of available remotes, it is 
impossible to advise which remotes will or will not work.

Please note: When learning from a second 
remote, you will likely find it does not have buttons 
that directly correspond with all available soundbar 
commands. Not all commands have to be pro-
grammed. Some remotes offer ‘function’ buttons (F1, 
F2, etc.) that can be used to program unique sound-
bar commands such as ‘NITE.MD’ or ‘OPTIC’.

Please note: Some remote controls offer discrete 
‘power on’ and ‘power off’ buttons. Some offer a 
single button to toggle power on and off. The learn-
ing function of the soundbar allows you to program 
either scenario.

LEARN: Enter the ‘LEARN’ submenu by pressing the 
enter button. The settings in this menu program the 
soundbar to respond to a second remote control. 
The factory supplied remote control will always 
work with the soundbar, even if the soundbar is 
programmed to respond to a second remote.

Using the up/down directional buttons, you can 
select and program the following commands:

• VOL+ [VOLUME +]
• VOL– [VOLUME –]
• MUTE [MUTE VOLUME]
• NX.INPT [NEXT INPUT]
• PR.INPT [PREVIOUS INPUT]
• UP
• DOWN
• LEFT
• RIGHT
• ENTER
• NITE.MD [NIGHT MODE]
• NRML.MD [NORMAL MODE]
• BASS.MD [BASS+ MODE]
• PWR.TGL [POWER TOGGLE] (toggle on/off)
• PWR.ON [POWER ON] (power on only)
• PWR.OFF [POWER OFF] (power off only)
• MENU
• OPTIC [OPTICAL INPUT] (direct access)
• COAX [COAXIAL INPUT] (direct access)