Инструкции Пользователя для Niles SI-1650

NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 1-760-710-0992

16 CHANNEL, FULLY CONFIGURABLE  POWER AMPLIFIERS

1.  Label all of the interconnecting cables for the sources 

they connect to.

Use audio patch cables with RCA phono plugs 
attached to the ends.

2. Connect the sources by inserting the RCA
plug into the amplifier’s jacks.

Connect outputs from your sources to inputs on
the amplifier. Never connect a source or
preamplifier’s input (e.g., record inputs) to the
inputs of your SI-1650.

The Cascade Audio Outputs enable you to connect another amplifier to your 
preamplifier output. The connectors are gold-plated RCA phono jacks. Connect 
them to another amplifier’s inputs with a standard audio patch cable. The 
outputs are not buffered; if you wish to daisy-chain more than 5 Niles amplifiers 
you will need a Niles AVDA-3 buffered distribution amplifier. If your preamp has 
a vacuum tube output stage, you must use a Niles AVDA-3 to drive more than a 
single SI-1650.

1.  Plug the female IEC socket of the supplied AC power 

cord (the supplied power cord is designed for 120V AC 
wall outlets), or use an appropriate IEC AC power cord 
to match the electrical wall outlet you are using (e.g. 
240V AC), into the IEC receptacle on the rear of the 
amplifier.  Replace the fuse in the bay below the power 
cord inlet with one of the 10A fuses provided if using a 
220-240V outlet.

If you use a grounded power strip, surge 
suppressor or extension cord, verify that proper 
ground is maintained.

CAUTION! Do not plug the amplifier’s cord into a 
preamplifier’s convenience outlets.

The SI-1650 draws a maximum of approximately 
1600 watts from an AC wall outlet. This is much 
more than the typical accessory outlet on the back 
of a component will provide. Use the SI-1650’s 
auto turn on circuitry to turn on the SI-1650 
whenever the preamp is on.