Справочник Пользователя для Selex ES SPA F567DHDE-HP

 

SELEX Communications 

 

 

The electrical wiring must be done using appropriate cables thus assuring the equipment responds to 

the electromagnetic compatibility standards. 

The cable terminates to flying connectors which have to be connected to the corresponding 

connectors on the equipment front. 

Position and pin–out of the equipment connectors are available in the appropriate section in the 

following of this document. 

The device is equipped with a ground nut located on the rear panel of the device and identified by a 

 label. This nut must be used for a direct connection of the device to the site grounding, even if the 

device is included in a cabinet. All antenna cables and DC power cabling should be properly grounded 

and lightning protected. Failure to provide proper lightning protection may result in permanent damage 

to the radio equipment. 

 

 

Ground 

M6 nut 

Section area ≥ 6 sq. mm