Справочник Пользователя для Shenzhen AEE Technology CO. LTD. AEEAP100001
AEE
Aerial Photography Equipment
Professional·Advanced
- 8 -
Install Propeller Guards
Please install the propeller guards according to the steps shown below:
1. Prepare AP10 aerial photography equipment (1 set), propeller guard (4pcs), M3.0×10 screw (8pcs), and
cross-head screwdriver (1pc).
2. Use the screwdriver to remove the two screws (M3.0×6) on the motor, as shown in the ovals in the figure below.
3. Tighten the two screws (M3.0×10) with proper force according to the dash lines shown in the figure below, and
install the four propeller guards. Do not use screw adhesive.
Note: If propeller guards are installed, M3.0×10 screws are used; if propeller guards are not installed, only M3.0×6
screws can be used, because the motors may get damaged if the screws are too long.
Install Battery
First move left the battery lock at the bottom of the aerial photography equipment towards the side with unlocking
design; push the battery case to the bottom by aligning it with the battery compartment; then move right the battery
lock towards the side with locking design.
Notice: Please make sure the power switch is in the OFF state during installation of the battery; after the
battery is installed, the battery lock must be moved to the locking position.