Справочник Пользователя для Essence Security International ltd. ES6500EGE
Operation
22
EverGuard Express
below.
For information on modifying and updating the EverGuard Express Control Panel
parameters using the ESI-CMS application, refer to the ESI-CMS chapter
parameters using the ESI-CMS application, refer to the ESI-CMS chapter
3.13.1 Transmitting the EverGuard Express Configuration
to the Monitoring Station
When you are finished programming the EverGuard Express panel by using the
AM, it sends the configuration to the Monitoring Station.
AM, it sends the configuration to the Monitoring Station.
3.13.2 Switching from ITS to CCS Mode
After the installation is finished, the panel sends ICO message containing the
activation code number. This number has to be entered by using the AM
application or by sending a remote command from the monitoring station.
activation code number. This number has to be entered by using the AM
application or by sending a remote command from the monitoring station.
3.13.3 Returning the EverGuard Express Panel to Factory
Default Settings
You can return the EverGuard Express panel to factory default parameter settings
using the Hard Reset function.
using the Hard Reset function.
To switch to factory default settings:
1. Insert the Programming tool point into the Programming button. The Status
LED flashes red and one good beep sounds.
2. Using the number keys, enter the master PIN code. The Status LED flashes
green and one good beep is sounded. Programming mode is initiated.
3. Using the number keys, press 99. The Status LED flashes green and one good
beep is sounded.
4. To confirm the reset, press 99 again. Three beeps confirm that the user is
defined. Programming mode automatically ends and the status LED turns off.
3.14 Arming and Disarming the System
The EverGuard Express control panel can arm the following system scenarios:
Full-arm - Arming the system in Full-Arm scenario activates all peripheral
devices contained defined in the EverGuard Express security system.
devices contained defined in the EverGuard Express security system.
Part Arm Day - The Day Scenario is configured as Day.
Part Arm Night - The Night Scenario is configured as Night.
Note: The specific security peripherals that are armed by each part Arm
scenario are defined during the initial system setup via the Atlas Mobile
application using the BlackBerry Smartphone, or via the ESI-CMS
application.
scenario are defined during the initial system setup via the Atlas Mobile
application using the BlackBerry Smartphone, or via the ESI-CMS
application.
For information on the initial setup of the EverGuard Express Security System
using the Atlas Mobile application via BlackBerry Smartphone, defining the
using the Atlas Mobile application via BlackBerry Smartphone, defining the