Справочник Пользователя для Essence Security International ltd. ES6502HC
ES6502HC Control Panel Specifications
Wireless communication with the peripherals:
•
•
Up to 1000 meters RF range (open air)
•
End‐to‐end bidirectional ESI protocol
•
Advanced radio supervision algorithm
•
Modulation: BFSK
•
Frequencies: 868.3 MHz or 916.5 MHz
•
Encoding: 32‐bit ID, over 4 billion
combinations
combinations
High quality, long range voice verification:
•
•
Two‐way Audio
•
Enhanced echo canceling DSP‐based algorithm
•
Speaker programmable gain
•
Ultra sensitive microphone
Safety Functionality:
•
•
Various Detectors (Water, Smoke, Gas, etc.)
•
Extreme Temperature Detection
•
Various panic (SOS) devices
Video (external camera):
•
•
High Resolution & Quality Color motion JPEG
Video* or JPEG Stills
Video* or JPEG Stills
Remote Control:
•
•
Automatic Software Upgrade
•
Remote Programming and Configuration
Electrical Power Supply:
•
•
Input: 100‐240 VAC, 50/60Hz ‐ external AC
adaptor
adaptor
•
Li‐Polymer rechargeable backup battery for up
to 36 hours ‐ 3.7V, 1.4Ah
to 36 hours ‐ 3.7V, 1.4Ah
Communication Modules:
•
•
Cellular Network: GSM/GPRS/EDGE/3G
•
Cellular Module: Quad band
(850/900/1800/1900 MHz)
(850/900/1800/1900 MHz)
Communication Modules:
•
•
Interfacing protocols: SIA or Essence
Proprietary Protocol (ESI)
Proprietary Protocol (ESI)
Physical:
•
•
Dimensions: 127x 127 x 72 mm (L x W x D)
•
Weight: 560 grams (incl. battery)
•
Color: White & Grey
•
Mounting: Desktop, Wall, with Bracket
Environmental:
•
•
Operating Temperatures: 0°~ 49° Celsius
General Features:
•
•
Personal Security
•
Multi language vocal reminders
•
Onboard SOS and call CMS buttons
•
LED indications for system status
Essence Security International (E.S.I.) Ltd.
www.essence‐grp.com
+972‐73‐244‐7777
info@essence‐grp.com
© 2013 Essence Security International (E.S.I.) Ltd. Information contained within this document may change without notice.
Certifications and approvals:
This device complies with FCC Rules Part 15 and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the party responsible for
compliance (Essence Ltd.) could void the user’s authority to operate the equipment.
WARNING! To comply with FCC and IC RF exposure compliance requirements, the device should be
located at a distance of at least 20 cm from all persons during normal operation. The antennas
used for this product must not be co-located or operated in conjunction with any other antenna or
transmitter.
Le dispositif doit être placé à une distance d'au moins 20 cm à partir de toutes les personnes au cours de son
fonctionnement normal. Les antennes utilisées pour ce produit ne doivent pas être situés ou exploités
conjointement avec une autre antenne ou transmetteur.