Справочник Пользователя для JET OPTOELECTRONICS CO. LTD. NBDVR4063
INSTALLATION
1. pen dust cover and i
gold contacts facing the back of the device . Push the memory card until it clicks into place and close dust cover.
Do not remove or insert the memory card when the iN-CAR CAM is turned on. This may damage the memory card.
gold contacts facing the back of the device . Push the memory card until it clicks into place and close dust cover.
Do not remove or insert the memory card when the iN-CAR CAM is turned on. This may damage the memory card.
2. Attach the device to the supplied windscreen mount, taking care the locking tab has clicked firmly into place.
3. Remove the protective plastic film from the suction pad. Select required position for the windscreen mount and
clean windscreen with a dry / clean cloth to achieve good contact between the glass and mount. While holding the
suction cup onto the glass push the locking lever upwards to secure the mount to the windscreen.
Please ensure that once mounted the iN-CAR CAM is located within the area of the vehicles windscreen wipers to
maintain a clear view during rainfall.
clean windscreen with a dry / clean cloth to achieve good contact between the glass and mount. While holding the
suction cup onto the glass push the locking lever upwards to secure the mount to the windscreen.
Please ensure that once mounted the iN-CAR CAM is located within the area of the vehicles windscreen wipers to
maintain a clear view during rainfall.
. The angle and position of the iN-CAR CAM can be adjusted by loosening the locking clamp and moving as required,
remembering to re-tighten the clamp.
. Connect the car adaptor to mini-USB socket of the iN-CAR CAM and then plug the supplied car adaptor into the
12-2 Vdc outlet of your vehicle. The device will automatically power on and start recording once power is available.
In some vehicles this will be when connections are made, for others the device will power on once the ignition has
been turned on.
In some vehicles this will be when connections are made, for others the device will power on once the ignition has
been turned on.
N TE:
our iNCAR-CAM is shipped with the Screen Saver function set to Default FF. This is for ease of initial setup.
nce setup is complete, the screen saver should be set to 1 seconds, in order to blank the screen completely
whilst driving. This avoids any potential distraction and may be a legal requirement in some countries.
whilst driving. This avoids any potential distraction and may be a legal requirement in some countries.
It is recommended to position your iNCAR-CAM on the passenger side of the car, behind the rear view mirror, as
shown above. Whilst the camera needs to be located in a position within the wiper swept area, do not allow the
camera to obstruct your vision of the road ahead. Recommended position is no more than 0mm within the wiper
swept area. Do N T mount the camera directly in front of the driver.
camera to obstruct your vision of the road ahead. Recommended position is no more than 0mm within the wiper
swept area. Do N T mount the camera directly in front of the driver.
Do not place the iN-CAR CAM in such a way that it may interfere with the deployment of air bags or other safety
equipment.
Do not operate the unit while driving.
To reduce the risk of theft, remove the unit and the mount from your vehicle, or position out of sight, before
leaving your vehicle unattended.
In vehicles where the 12V / 2 V output remains on when ignition is turned off please disconnect the device when
not in use.
The supplied car adaptor has a m long cable to allow cable to placed neatly within the vehicle.
First time use of the device will require the Time and Date to be set. See Page 10 for details.
nsert a suitable memory card in to the device, taking care to follow correct orientation markings
The above diagram is f
.
or illustration purposes only
12-2
DC
Eng
lish
05