Справочник Пользователя для Graupner GmbH & Co. KG MC-20

229

The menus gathered under the heading »Telemetry«
can be called up from the 

mc-20

 HoTT transmitter's 

basic display with a tap of about one second duration 
on the center 

 key of the left touch pad. The 

same menus can, like other transmitter menus, also 
be opened in the multifunction menu with a tap on the 
center

 key of the right touch pad:

Wing mixers

Free mixers

MIX active/phase

MIX-only channel

Dual mixer

Fail-safe adjust

Teacher / pupil

Tx. output swap

Profi trim

Trim memor y

Telemetr y

Channel sequence

Free mixers

MIX active/phase

MIX-only channel

Dual mixer

Swashplate mixer

Fail-safe adjust

Teacher / pupil

Tx. output swap

Profi trim

Trim memor y

Telemetr y

Channel sequence

 Basic operation
Operating the »Telemetry« menu is essentially the 
same as for the remaining 

mc-20

 HoTT transmitter 

menus. The few differences are described in the 
following:
The

ef selection keys of the left or right touch pad 

can be used to switch between individual pages 
of the Telemetry menu. Corresponding directional 
indicators can be found at top right of each display 
page in the form of angled brackets (

), refer to the 

fi gures below. If only one angled bracket is visible, 
you are on either the fi rst or last respective page. 
In this case, changing pages is only possible in the 

indicated direction.
Menu lines in which parameters can be changed are 
identifi ed with the aforementioned angled bracket ( ). 
The " " pointer will jump a line forward or back with 
a tap on the 

cd selection keys of the left or right 

touch pad. Lines to which a jump cannot be made 
are unalterable.
In order to change a parameter, briefl y touch the 
center

 key of the right touch pad (the parameter 

will be displayed in inverse video), change the value 
within the permissible adjustment range via the 
selection keys of the right touch pad and adopt the 
value with another tap on the 

 key. A brief tap on 

the center 

 key of the left 4-way pad will cause a 

return to the starting position again.
Now use the 

cd selection keys of the left or right 

touch pad to pick the desired sub-menu. However, if 
the message …

… appears instead of the desired sub-menu after 
touching the center 

 key of the right touch pad 

then no connection has been established with a 
receiver. Therefore, switch on your receiver system 
or, if applicable reconnect the addressed receiver as 
described on page 77 or 85 or activate it as described 
under "Important Notices" on the previous page.

On the fi rst display page of the sub-menu overwritten 
with …

…

… no settings can be made. This page is only 
provided for information:

S-QUA

signal quality in %

S-dBm

Reception power in dBm

S-STR

signal strength in %

R-TEM.

Receiver temperature in °C

L PACK 
TIME

Indicates the time in ms in which the 
longest data package is lost during the 
transmission from the transmitter to the 
receiver

R-VOLT

Current operating voltage of the 
receiver in volts

   SETTINGS/DISPLAYS