Справочник Пользователя для Graupner GmbH & Co. KG MC-20

239

programming, such as fail-safe settings, 
disconnect the three-pole satellite connection 
between the two receivers and switch on only 
the relevant receiver. It may be necessary to also 
change the connection sequence.

If, in addition to a "receiver", at least one sensor 
is selected in the »Telemetry« menu's »SENSOR
SELECT« sub-menu (described below) then 
its settings can be read in and changed on the 
previously described receiver screens. 
However, to actually gain access to this data, the 
selected sensor/s must be connected to the receiver 
system and this receiver system must have an active 
telemetry connection. 
If, as described in the next section, there is at least 
one sensor activated which has the support of current 
fi rmware, then it is possible to directly switch between 
individual modules. However, if sensors with older 
fi rmware are in use, it may be necessary to select 
"etc." instead of the direct sensor selection. 
In either case, tap the 

c or d selection key of the left

touch pad … 

… then use the same keys to select up or down for 
the desired module, for example:

If the selected module, in this case a Vario module, 
is active then on the last receiver screen ("RX 
SERVO TEST"), at the top right there will also be 
an additional " " symbol pointing to the right. This 
symbol is located just to the right of the left-pointing "

" symbol and is the visible indicator that additional 

display screens can be accessed.

Now use one of the 

f selection keys on the left or 

right touch pad to switch to the selected sensor's 
displays and check or change its settings as 
described in the manual delivered with the sensor.