Справочник Пользователя для Graupner GmbH & Co. KG MC-20

36

The

mc-20

 transmitter has two independent displays; 

a large display for operating the transmitter and a 
smaller display just below the antenna socket for 
the graphic display of telemetry data. The telemetry 
display is activated automatically as soon as the 
transmitter receives telemetry data from the receiver 
via the return channel.

#01

0:00h

Stopwatch

Flight tim

0:00.0

4.1V

0:00.0

0

0

0

0

0:00h

M

If however, at the lower edge of the base display, only 
"X" – as shown in the fi gure above – is displayed at 
two locations instead of " " then the telemetry display 
will show the warning …

… which will be replaced shortly thereafter with the 
Graupner|SJ logo and the transmitter names …

mc32

… to indicate there is no receiver with a responding 
telemetry connection within range. Switch on the 
model's receiver system or bind a receiver to the 
active model memory as described in detail on 
page 77 and 85.

#01

0:00h

Stop watch

Flight tim

0:00

4.1V

0:00

0

0

0

0

0:00h

M

RX VOLT:4.8V

When a telemetry connection exists, the upper display 
will automatically present the "Receiver" screen …

… which is described in more detail in a section by 
the same name on the next page.

Sensor Select
Up to four sensors can be connected, in any 
combination, to a telemetry-capable receiver. 
However, the data output by these sensors must be 
(as described on page 240) selected in the »SENSOR 
SELECT« sub-menu of the »Telemetry« menu …

… in order to activate their display. This data from 
the selected sensors is then appropriately prepared 
for illustration by the graphic indicators as described 
below. Furthermore, only sensors activated in 
the »SETTING & DATAVIEW« sub-menu of the 

»Telemetry« menu, beginning page 229, according 
to the instructions included with the given sensor will 
be responsive.
To switch between the screens for activated sensors 
in the »SENSOR SELECT« sub-menu of the 
»Telemetry« menu, tap briefl y on one of the 

cd

selection keys of the left or right touch pad …

G E N E R A L

E L E C T .   A I R

V A R I O

G P S

R E C E I V E R

… and, after the selected screen has been displayed, 
use one of the 

cd two keys to select the line of 

the desired sensor. If no sensor is activated, then 
all display lines and sensors described in the next 
column, except for the "RECEIVER" line, are blended 
out of the display and the selection list:

G E N E R A L

E L E C T .   A I R

V A R I O

G P S

R E C E I V E R

The selection can be confi rmed right away by 
activating the center 

 key of the right touch pad 

or by simply waiting until, after a brief pause, the 
main display of the given selected sensor appears 
automatically. 

f key.

More details about the following named modules 
can be found in the appendix and in Internet at 

  Telemetry data display