Справочник Пользователя для ICable System Co. Ltd. ICS-G101C
Page 6
Chapter
2.0
INSTALLATION
.
2.1 Typical Installation Procedure
Please follow the steps below very closely:
STEP 1 Power off your broadband modem and computer.
STEP 2 Disconnect the Ethernet cable from your computer and connect it to the
“WAN” port on the ICS-G101C.
STEP 3 Connect either end of the Ethernet cable shipped with the ICS-G101C into
the PC port on the ICS-G101C, then connect the other end into the Ethernet
port on your computer.
STEP 4 Connect a telephone cable (RJ11) from “TEL” port on the ICS-G101C to
your telephone.
STEP 5 Connect PSTN telephony Line to “PSTN” port on the ICS-G101C
STEP 6 Connect the power adaptor that was shipped with the ICS-G101C into
the power port on the ICS-G101C then plug the adaptor into your power
source.
STEP 7 Power on your broadband modem and power on the ICS-G101C using
the white on/off button located on the back of the ICS-G101C, then
power on your computer. (Fig: 2.2.4 “page 7”)
STEP 8 Check to make sure that your computer is set to automatically receive a
dynamic IP address. Please refer to page 5 section 2.2 Dynamic IP
mode