Справочник Пользователя для INNOSYS Co. LTD. ER300A
ECHO Rev A INSTALLATION
MANUAL
I
6
INNOSYS
1. Parking light will flash in group of 1 to 6 flashes to report shut down reason. (See table below)
2. To exit this mode, turn off ignition.
2. To exit this mode, turn off ignition.
Parking Light Flash
Shut Down Reason
Remedy
2 times
Key is On position
Check Key cylinder
3 times
Door Opened
Check Door pin
6 times
Not in Reservation
Put into Reservation Mode
3.6 Remote Engine Stop
1. Press and release the transmitter button #3 for approximately two seconds.
2. Engine stops running. Two chirps and two light flashes will verify the operation.
2. Engine stops running. Two chirps and two light flashes will verify the operation.
Optional Remote Entry Method
1. Press and release the transmitter button #1.
2. Doors will unlock and the system will disarm.
3. Enter your vehicle and insert your key in the key cylinder. If you do not open the door in 20 seconds,
2. Doors will unlock and the system will disarm.
3. Enter your vehicle and insert your key in the key cylinder. If you do not open the door in 20 seconds,
the system will automatically arm and lock the system.
4. Turn your key to ON position (Normal driving position).
WARNING: Do not attempt to start your vehicle! Your vehicle has started and it is already running.
5. Press and release the brake. The remote start functions turn off but the engine is still running due to
the key in the driving position.
6. Put in gear and drive normally.
SECTION 4: SYSTEM OPERATION (Enhanced Function)
4.1 One Time Soft Chirp
Arm/Disarm chirp can be temporarily softened from your remote the transmitter.
To use temporary chirp disable,
1. PRESS AND RELEASE THE TRANSMITTER BUTTON #2.
2. Press and release the transmitter button #1, #2 or #3 for desired function.
Example: To arm the system with soft chirp sound, press button #2 first. Then press button #1.
1. PRESS AND RELEASE THE TRANSMITTER BUTTON #2.
2. Press and release the transmitter button #1, #2 or #3 for desired function.
Example: To arm the system with soft chirp sound, press button #2 first. Then press button #1.
4.2 Emergency Disarm with a Key (If you lost a remote and can not shut off the alarm system)
1. Turn ignition key on and off five (5) times within ten (10) seconds (2.5 seconds each on/off cycle).
2. If your key is correct, the system will disarm immediately.
2. If your key is correct, the system will disarm immediately.
4.3 3rd Channel control (Optional)
1. Press and hold down the transmitter button #4 for approximately two seconds.
2. One chirp sound and one flashing light signal verify the operation.
3. Installed optional function will operate.
2. One chirp sound and one flashing light signal verify the operation.
3. Installed optional function will operate.
4.4 Turbo Cool Down Mode (If remote start is installed.)
Turbo Cool Down means that vehicles with turbo engines can be cooled down by using this function. Since
those vehicles with turbo engines need to have an engine cool down period of at least 2 minutes after driving,
this feature will leave the engine on after the ignition key is turned off and removed from the ignition. Engine
automatically turns off after 2 minutes.
With the engine on, step on the brake. Then press and hold the transmitter button #3 for Turbo Cool Down
Mode
those vehicles with turbo engines need to have an engine cool down period of at least 2 minutes after driving,
this feature will leave the engine on after the ignition key is turned off and removed from the ignition. Engine
automatically turns off after 2 minutes.
With the engine on, step on the brake. Then press and hold the transmitter button #3 for Turbo Cool Down
Mode
1. One chirp sound and one parking light flash will confirm Turbo Cool Down Mode
2. Engine will stay running even after the key is removed. Exit the vehicle.
3. Press and release the transmitter button #3 to arm the system.
4. Engine will shut off in 2 minutes for Turbo Cool Down Mode
5. To turn off the engine before the run time period, press and release the transmitter button #2.
2. Engine will stay running even after the key is removed. Exit the vehicle.
3. Press and release the transmitter button #3 to arm the system.
4. Engine will shut off in 2 minutes for Turbo Cool Down Mode
5. To turn off the engine before the run time period, press and release the transmitter button #2.