Справочник Пользователя для Diffraction Limited MD1
MaxDome
16
GND
Ground return for 12V input
Each of these will be described in more detail below.
Motor Control Wiring
There are two motors; one for the upper shutter and one for the lower. Both are
wired identically.
Make sure that the Upper terminals are connected to the Upper motor, and the
Lower terminals are connected to the Lower motor. Otherwise the shutters will
not sequence properly and will bind.
wired identically.
Make sure that the Upper terminals are connected to the Upper motor, and the
Lower terminals are connected to the Lower motor. Otherwise the shutters will
not sequence properly and will bind.
Motor Driver Board
The Open/Close wires go from the Dome Controller board to the Motor Driver
board. The wires may be connected in parallel with the manual switch at the
Motor Driver board.
A ground wire must also be connected between the boards. This provides a
return path for the control lines. This wire can be connected to any of the
terminals marked GND.
Note that, if for some reason the dome rotates in the wrong direction, the Open
and Close wires can be swapped.
Magnetic Closed Sensor Wiring