Справочник Пользователя для SmartLabs Inc. 2475F
Page 7 of 13 Rev: 12/7/2011 3:09 PM
1) Tap FanLinc’s Fan Set button until FanLinc’s Beeper & LED indicate the desired fan speed
NOTE: For your safety the fan will not spin when the Fan Set button is pressed, only incoming
INSTEON commands will initiate fan speed control.
INSTEON commands will initiate fan speed control.
Tap
Fan Speed
Beeper
LED
1
st
Low
Single Beep
Blinks Green Slow
2
nd
Medium
Double Beep
Blinks Green Medium
3
rd
High
Fast Double Beep
Blinks Green Fast
4
th
Off
None
Red
Fan’s LED will be in the desired state (see table above)
2) Press & hold the scene controller Set button until it beeps
1
Controller’s LED will blink
3) Press & hold FanLinc’s Fan Set button until FanLinc double-beeps
Fan’s LED will (Beep)-(Beep) and the LED will return to previous state.
Controller will (Beep)-(Beep)
1
and its LED will stop blinking
4) If you wish to add your fan to more scenes, simply repeat these steps
5)
Temporarily hang the fan from the mounting ring so the fan can spin safely and without
obstruction. Then while safely clear of the fan blades
obstruction. Then while safely clear of the fan blades
press On / Off on your scene controller
Fan’s LED will toggle between Green scene state and
RED (Off)
Remove FanLinc from a Scene
If you are going to discontinue using FanLinc, it is very important that you Un-link it from all of its scene
controllers. Otherwise, the controllers will retry commands repetitively, creating network delays. These
instructions remove FanLinc from a scene for which it is a responder. Whenever possible, use software
for managing links.
controllers. Otherwise, the controllers will retry commands repetitively, creating network delays. These
instructions remove FanLinc from a scene for which it is a responder. Whenever possible, use software
for managing links.
WARNING: Prior to proceeding, use the pull chain to turn the fan motor to Off.
1) Tap the button you wish to unlink. Press & hold the controller’s Set button until Controller beeps
2
Controller’s LED will blink
2) Press & hold the Set button until controller beeps again
1
Controller’s LED will continue blinking
3) If you wish to remove FanLinc’s
Light from the scene – press & hold FanLinc’s Light Set button until
it double-beeps
Light’s LED will flash once & return to steady
GREEN
(or
RED
)
4) If you wish to remove FanLinc’s
Fan from the scene – press & hold FanLinc’s Fan Set button until it
double-beeps
Fan’s LED will flash once & return to blinking
GREEN
(or steady
RED
)
Controller’s LED will stop blinking
1
Most models
2
For devices without beepers hold until its LED begins blinking (this may take 10+ seconds)