Справочник Пользователя для Appro Technology Inc RF1

3.2 Mounting and Positioning the Compact dome

Camera Mounting: (refer to Figure3.2.1~3.2.6)

Step 1: Position the alignment sticker in the desired location for the camera.

Step 2: Use a 6mm drill bit to make required holes approximately 25mm deep.

Step 3: Insert wall anchors.

Step 4: Affix the camera base using the screws provided.

Step 5: Adjust the Lens.

Step 6: Affix the dome using the screws provided.

Step 7: Insert the weatherproof rubber screw coverings over the screws ensuring a tight seal.

ngs over the screws ensuring a tight seal.

Step 8: Using the Ethernet cable connect to the Ethernet port. Connect the other end of the

Ethernet cable your network. If you are using a PoE hub, connect the IP camera to the hub via an

Ethernet cable, which will provide transmission of both power and data over a single cable.

Step 8: Using the Ethernet cable connect to the Ethernet port. Connect the other end of the

Ethernet cable your network. If you are using a PoE hub, connect the IP camera to the hub via an

Ethernet cable, which will provide transmission of both power and data over a single cable.

Step 9: Connection with 12V DC Power Adaptor.

Figure 3.2.1

Figure 3.2.2

Figure 3.2.3

Figure 3.2.4

Figure 3.2.5

Figure 3.2.6