Справочник Пользователя для myon AG M320-1
Image 11: Proper EMG signal recording
9.3.2 Visualization of transmission errors
The visualization of transmission errors is done in two different ways:
•
If the wireless connection between a transmitter and the receiver is broken only shortly for
less than one second, the receiver will output a zero amplitude signal on the affected
channel.
In most cases only one or two frames of transmission may be lost, resulting in a signal drop
to zero for 5 or 10 ms. The example in Image 12 below shows a longer drop in transmission
for about 150 ms.
less than one second, the receiver will output a zero amplitude signal on the affected
channel.
In most cases only one or two frames of transmission may be lost, resulting in a signal drop
to zero for 5 or 10 ms. The example in Image 12 below shows a longer drop in transmission
for about 150 ms.
Image 12: Visualization of short transmission errors
•
If the wireless connection between a transmitter and the receiver is broken for more than
one second (e.g. because of a transmitter switching itself off due to battery drainage or
because the distance between the transmitting module and receiving unit is exceeded), the
receiving unit will output a sine signal with maximum output amplitude (+/- 2,5 Volts) on
the affected channel.
one second (e.g. because of a transmitter switching itself off due to battery drainage or
because the distance between the transmitting module and receiving unit is exceeded), the
receiving unit will output a sine signal with maximum output amplitude (+/- 2,5 Volts) on
the affected channel.
Date: 03.06.2013
LaInMa-EU-m320 - Instructions manual (full version, english) - 20130603 - V1.7.odt
Page 28 of 32
V
E
R
S
IO
N
1
.7
/
0
3.
0
6
.2
0
13