Справочник Пользователя для EnOcean GmbH EOSC01

If light levels are very low where the sensor is installed, auxiliary 

battery power (CR2032) can be used to supplement the solar 

energy harvester.
1.  Remove the sensor from the mounting plate. 

 

With the push-button interface facing you, slide the sensor 

to the right.

2.  Turn the sensor over and identify the battery holder on the 

circuit board 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3.  Insert the battery under the clip with the positive pole (+) up 

and press it in place.

4.  Remount the sensor on the mounting plate.

Sensor does not 

generate a wireless 

message

 ▪

Verify the LED blinks when motion is detected 

during a walk test

 ▪

Verify the solar cell is charged properly

Sensor is activated 

when there is noth-

ing to detect

 ▪

Verify there is 4 ft. (1.2 m) clearance from heat 

sources that may disturb sensing

 ▪

Reduce sensitivity setting by moving the PIR 

sensitivity switch on the back to low (the left-

hand position)

Linked device does 

not respond to 

wireless messages

 ▪

Check for environment or range issues

 ▪

Verify the device is linked

 ▪

Check the transceiver connection and the wir-

ing for errors

 ▪

Check if appropriate devices are linked accord-

ing to good system planning

 
 

FCC SZV-EOSC01 

  

IC 5713A-EOSC01

This device complies with part 15 of the FCC rules and Industry Canada ICES-003. Operation 

is subject to the following two conditions: (1) This device may not cause harmful interference, 

and (2) this device must accept any interference received, including interference that may 

cause undesired operation.
IMPORTANT! Any changes or modifications not expressly approved by the party responsible 

for compliance could void the user’s authority to operate this equipment. 
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio 

exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne 

doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage 

radioélectrique subi, meme si le brouillage est susceptible d’en compromettre le fonc-

tionnement. 
IMPORTANT! Tous les changements ou modifications pas expressément approuvés par la 

partie responsable de la conformité ont pu vider l’autorité de l’utilisateur pour actioner cet 

équipment. 

Limited Warranty
Subject to the other terms of this warranty, the manufacturer warrants you the original 

purchaser that this product will be free from defects in material and workmanship for one year 

from the date of your purchase of the product. During that period, if the product does not 

comply with this limited warranty, the manufacturer will, at its discretion, repair or replace the 

product. Repair or replacement is your sole remedy under this or any other warranty of the 

product, whether express or implied.
Coverage Limitations. This limited warranty extends only to the original purchaser and is 

not transferable. This limited warranty expressly excludes any defects or damages resulting 

from any product installed improperly or in an improper environment, overloaded, misused, 

opened, abused, or altered in any manner.
To obtain warranty service - return the product, a description of the problem, together with 

your proof of purchase, securely packaged and with postage prepaid, to the manufacturer.
You may be required to provide other information or evidence of the defect. Any returned 

product that is replaced becomes the property of thye manufacturer.
Implied Warranties. TO THE EXTENT PERMITTED BY LAW, ANY IMPLIED WARRANTIES, IN-

CLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, 

ARE LIMITED TO THE SAME DURATION AS THIS EXPRESS WARRANTY. Some states do not 

allow limitations on how long an implied warranty lasts, so the above limitation may not apply 

to you. NO OTHER EXPRESS WARRANTY HAS BEEN MADE OR WILL BE MADE BY THE MANU-

FACTURER WITH RESPECT TO THIS PRODUCT.
Limitation of Liability. THE MANUFACTURER SHALL NOT BE RESPONSIBLE FOR SPECIAL, 

INCIDENTAL OR CONSEQUENTIAL DAMAGES SUCH AS THE COST OF LABOR FOR REMOVAL 

OR REINSTALLATION OF THE PRODUCT, WHETHER ARISING OUT OF BREACH OF WARRANTY, 

BREACH OF CONTRACT, TORT, OR OTHERWISE. Some states do not allow the exclusion of inci-

dental or consequential damages, so the above exclusion and limitation may not apply to you.
This limited warranty gives you specific legal rights, and you also may have other rights which 

vary from state to state. In Canada, the above provisions are not intended to operate where 

prohibited by law and do not preclude the operation of any applicable provisional consumer 

protection statute which in certain circumstances may extend the express warranties herein.

Occupancy Sensor – Ceiling Mounted • Installation Guide

Page 4