Справочник Пользователя для EnOcean GmbH PTM215B
USER MANUAL
PTM 215B – 2.4 GHZ Pusbutton Transmitter Module
© 2016 EnOcean | www.enocean.com
F-710-017, V1.0
PTM 215B User Manual | v0.8 | September 2016 | Page 14/42
2.8.2
Radio-based commissioning mode
Radio-based commissioning mode is used to associate PTM 215B with other devices. To do
so, PTM 215B can transmit a dedicated commissioning telegram (as described in chapter
2.9.6.2) identifying its relevant parameters. The commissioning telegram will be transmit-
ted on the BLE advertising channels (Channels 37, 38 and 39)
Radio-based commissioning mode is intended for applications where NFC commissioning
(as described in chapter 2.11) cannot be used.
Radio-based commissioning can be disabled by setting the Disable Radio Commissioning
flag in the Configuration register to 0b1 (see chapter 2.11.4.2).
2.8.2.1 Commissioning mode entry
Commissioning mode is entered using a special button contact sequence. This is illustrated
in Figure 7 below.
Figure 7 – Button sequence for commissioning mode
To enter commissioning mode, start by selecting one button contact of PTM 215B. Any con-
tact of PTM 215B (A0, A1, B0, B1) can be used. This contact is referred to as Button_X in
Figure 7 above.
Next, execute the following long-short-long sequence:
1. Press and hold the selected button contact together with the energy bar for more
than 7 seconds before releasing it
2. Press the selected button contact together with the energy bar quickly (hold for less
than 2 seconds)
3. Press and hold the selected button contact together with the energy bar again for
more than 7 seconds before releasing it
Upon detection of this sequence, PTM 215B will enter commissioning mode if the Disable
Radio Commissioning flag in the configuration register is not set.