Справочник Пользователя для EnOcean GmbH STM310C

USER MANUAL V0.6

STM 31x / STM 31xC User Manual V0.6 | Page 26/28

STM 31X / STM 31XC

4.2 FCC (United States) certification

STM 31xC LIMITED MODULAR APPROVAL
This is an RF module approved for Limited Modular use operating as an intentional trans-

mitting device with respect to 47 CFR 15.231(a-c) and is limited to OEM installation. The

module is optimized to operate using small amounts of harvested energy, such as can be

collected by a small solar cell exposed to ambient light. The module transmits short radio

packets comprised of control signals, (in some cases the control signal may be accompa-

nied with data) such as those used with alarm systems, door openers, remote switches,

and the like. The module does not support continuous streaming of voice, video, or any

other forms of streaming data; it sends only short packets containing control signals and

possibly data and is typically powered by a solar cell in ambient light. The module is de-

signed to comply with, has been tested according to 15.231(a-c), and has been found to

comply with each requirement. Thus, a finished device containing the STM 31xC radio mod-

ule can be operated in the United States without additional Part 15 FCC approval (ap-

proval(s) for unintentional radiators may be required for the OEM’s finished product), under

EnOcean’s FCC ID number. This greatly simplifies and shortens the design cycle and devel-

opment costs for OEM integrators.
The module can be triggered manually or automatically, which cases are described below.

Manual Activation

The radio module can be configured to transmit a short packetized control signal if

triggered manually. The module can be triggered, by pressing a switch, for example.

The packet contains one (or more) control signals that is(are) intended to control

something at the receiving end. The packet may also contain data. Depending on

how much energy is available from the energy source, subsequent manual triggers

can initiate the transmission of additional control signals. This may be necessary if

prior packet(s) was (were) lost to fading or interference. Subsequent triggers can

also be initiated as a precaution if any doubt exists that the first packet didn’t arrive

at the receiver. Each packet that is transmitted, regardless of whether it was the

first one or a subsequent one, will only be transmitted if enough energy is available

from the energy source.
Automatic Activation

The radio module also can be configured to transmit a short packetized control sig-

nal if triggered automatically, by a relevant change of its inputs, for example. Again,

the packet contains a control signal that is intended to control something at the re-

ceiving end and may also contain data. As above, it is possible for the packet to get

lost and never reach the receiver. However, if enough energy is available from the

energy source, and the module has been configured to do so, then another packet or

packets containing the control signal may be transmitted at a later, unpredictable

time.