Справочник Пользователя для Impinj Inc. XARRAY
Speedway Revolution Installation and Operations Guide Octane 4.11
Chapter 3: Configuring and Monitoring
Revision 4.11 Copyright © 2014, Impinj, Inc.
17
Chapter 3: Configuring and Monitoring
Speedway Revolution
Speedway Revolution
This chapter provides a high-level view of the configuration and monitoring options available
for Speedway Revolution.
for Speedway Revolution.
Configuring Speedway Revolution
You can think of Speedway Revolution configuration in two categories: configuring the
device itself and configuring the Reader‘s RF behavior. This chapter provides the basics for
each type of configuration.
device itself and configuring the Reader‘s RF behavior. This chapter provides the basics for
each type of configuration.
Device Configuration
RShell is a proprietary command line management interface for configuring and managing
network settings, firmware upgrades, and other device-oriented operations. This chapter
introduces the RShell commands for installing and connecting the Reader. RShell Reference
Manual provides full details and syntax for all RShell commands.
network settings, firmware upgrades, and other device-oriented operations. This chapter
introduces the RShell commands for installing and connecting the Reader. RShell Reference
Manual provides full details and syntax for all RShell commands.
Note
: RShell is a machine interface and is almost always backward-compatible with
previous Speedway Revolution versions. Existing inputs and outputs will never change.
When adding new commands, new optional arguments will be added at the end.
When adding new commands, new optional arguments will be added at the end.
Using RShell to Configure Network Settings for Speedway Revolution
You can often get up and running with little or no configuration using the default
configuration settings in Speedway Revolution. If you are not using DHCP to assign IP
addresses, you will need to configure a few of the Reader‘s network settings.
The following procedure outlines the RShell commands you may need for connecting the
Reader to your network.
configuration settings in Speedway Revolution. If you are not using DHCP to assign IP
addresses, you will need to configure a few of the Reader‘s network settings.
The following procedure outlines the RShell commands you may need for connecting the
Reader to your network.
To configure the Reader
’s network settings:
(see page 13 for details).
2. View the Reader‘s current configuration settings by entering the show network
summary
command at the RShell command prompt:
> show network summary
Status='0,Success'
PrimaryInterface='eth0'
ActiveInterface='eth0'
Hostname='SpeedwayR-00-00-B9'
connectionStatus='Connected'
ipAddressMode='Dynamic'
ipAddress='10.0.10.41'
ipMask='255.255.0.0'
gatewayAddress='10.0.0.10'
broadcastAddress='10.0.255.255'
LLAStatus='enabled'
Status='0,Success'
PrimaryInterface='eth0'
ActiveInterface='eth0'
Hostname='SpeedwayR-00-00-B9'
connectionStatus='Connected'
ipAddressMode='Dynamic'
ipAddress='10.0.10.41'
ipMask='255.255.0.0'
gatewayAddress='10.0.0.10'
broadcastAddress='10.0.255.255'
LLAStatus='enabled'
3. Configure the appropriate TCP/IP parameters for your environment. The applicable
commands are: