Справочник Пользователя для Chuang Feng Electronics Co. Ltd. KM1015SW
Troubleshooting
Difficulities
Solutions
Please check if the LED light under the scroll
wheel is still flashing ,if flashing,it implies that
the battery is poor and please try to change the
battery .
Please unplug the receiver and plug it again to
USB port ,or take out the battery and refix it
after 20 seconds.
Mouse has no
reaction at all
Please unplug and then plug it again into USB
port, if fail to react,please try another USB port
or change the PC for the test.
Mouse acts slow
suddenly during the
course of normal
usage
Mouse disconnects
during the course of
working
Caution :
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Compliance statement:
1: This device is verified to comply with Part 15 of the FCC Rules. Operation
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
2: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However,there is no guarantee that
interference will not occur in a particular installation.If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.