Справочник Пользователя для EMBEDTEK-RFT LLC ET915TRANSM1
Page 2 of 3
INSTALLATION
AC power supply connection:
Warning: Turn power off before you connect this device to your power supply.
Make sure your power supply voltage matches the receiver power supply
requirements: 120 VAC or 277 VAC.
Attach the power cable to the female Mate N Loc connector located in the housing of the
2WT-2RA-6A unit.
Load Connection:
Warning: Make sure the power supply voltage matches the voltage of the load to be
controlled. Otherwise fire or damage to the device or load may occur and it may
cause electrical shock.
A male Mate N Loc connector is located at the end of the cable protruding from the
2WT-2RA-R6 housing which plugs into the load to be controlled.
Warning: Make sure the load to be connected does not exceed the relay rating. Otherwise
fire or damage to the device may occur. Please refer to TECHNICAL DATA for relay
rating.
OPERATION
Warning: Make sure your power supply voltage matches the receiver power supply
requirements: 120 VAC or 277 VAC. Otherwise there is electrical shock hazard.
Warning: The load must match the relay rating. Otherwise fire or damage to the receiver
may occur.
After the master and slave devices are properly connected to the power supply and load,
turn the power on. The load attached to the slave device(s) can then be turned on or off
by the 2WT-2RA-R6 master device.
AC power supply connection:
Warning: Turn power off before you connect this device to your power supply.
Make sure your power supply voltage matches the receiver power supply
requirements: 120 VAC or 277 VAC.
Attach the power cable to the female Mate N Loc connector located in the housing of the
2WT-2RA-6A unit.
Load Connection:
Warning: Make sure the power supply voltage matches the voltage of the load to be
controlled. Otherwise fire or damage to the device or load may occur and it may
cause electrical shock.
A male Mate N Loc connector is located at the end of the cable protruding from the
2WT-2RA-R6 housing which plugs into the load to be controlled.
Warning: Make sure the load to be connected does not exceed the relay rating. Otherwise
fire or damage to the device may occur. Please refer to TECHNICAL DATA for relay
rating.
OPERATION
Warning: Make sure your power supply voltage matches the receiver power supply
requirements: 120 VAC or 277 VAC. Otherwise there is electrical shock hazard.
Warning: The load must match the relay rating. Otherwise fire or damage to the receiver
may occur.
After the master and slave devices are properly connected to the power supply and load,
turn the power on. The load attached to the slave device(s) can then be turned on or off
by the 2WT-2RA-R6 master device.
TECHNICAL DATA
Power Supply: 120 VAC or 277 VAC.
Antenna: Internal.
Frequency: 915 MHz
Operation Temperature: -20
Power Supply: 120 VAC or 277 VAC.
Antenna: Internal.
Frequency: 915 MHz
Operation Temperature: -20
o
C to 60
o
C (-4
o
F to 140
o
F)
Number of relays on receiver: 2
Each relay rating:
Each relay rating:
• 20A resistive load 277 VAC
• 10A Ballast load 120/277 VA
• 10A Ballast load 120/277 VA
Certification: FCC compliance
This device complies with Part 15 of the FCC Rules. If this device is operated in
compliance with the following requirements, it can be operated without notification and
free of charge in the area of the United States of America.
compliance with the following requirements, it can be operated without notification and
free of charge in the area of the United States of America.