Справочник Пользователя для Caretaker Systems Inc. 3-204-35

25

Battery: 3 Volt,
Lithium
T

2032

ON

 1    2

Channel

Channel

1    2

ON

1    2

ON

Channel

1    2

Channel

1

(Factor

ON

CHANGING THE REMOTE CONTROLLER CHANNEL, AND REPLACING THE BATTERY
The Remote Controller provided with the Prevent system is capable of operating on four different
channels.  The factory setting is Channel 1.  Occasionally, due to interference from other nearby
radio frequency devices, it is necessary to change to a different channel.  Proceed as shown
below.

•

 Enter the Set-Up Mode by

clicking the Remote 4 CLICKS.

•

 Remove the cover from the

Transceiver.

•

 Open the Remote Controller by

removing the four screws from
the bottom.

•

 Set switches #1 & #2 in the

Remote Controller, and switches
#5 & #6 in the Transceiver to
match one of the Channel
combinations shown at the right.

•

 Do not change any other switch

settings.

•

  Replace the covers.

•

  Click the Remote 1 CLICK to

reset the system.

The life of the battery in the Remote Controller will vary with
the amount of use of the unit. It is recommended that the
battery be replaced once each year.

Transceiver:
Green Solid Light = Functional and Active
Green Blinking = In Set-up or Swim Mode
Red Light Off = Batteries are charged and functional
Red Light Blinking = Batteries are low, check batteries. 

Refer to Page 14 for battery replacement instructions

Remote Controller:
Red Light Blinks when button pushed = Normal function
No Red Light when button pushed = Batteries need to be replaced