Справочник Пользователя для Interepoch Technology Inc. IWE1300
16
Link Monitor. When the AP is in AP Client mode, this page shows the signal strength and
link quality of the wireless link to its associated access point.
link quality of the wireless link to its associated access point.
z
General. Global operations.
Operational Mode. Operational mode of the AP—AP/Bridge or AP Client.
Password. For gaining rights to change the settings of the AP.
Firmware Tools. For upgrading the firmware of the AP, backing up and restoring con-
figuration, and configuration reset settings of the AP.
figuration, and configuration reset settings of the AP.
z
TCP/IP. TCP/IP-related settings.
Addressing. IP address settings for the AP to work with TCP/IP.
DHCP Server. Settings for the DHCP (Dynamic Host Configuration Protocol) server on
the AP.
the AP.
z
IEEE 802.11. IEEE 802.11g-related settings.
Communication. Basic settings for the IEEE 802.11g interface of the AP to work prop-
erly with wireless clients.
erly with wireless clients.
Security. Security settings for authenticating wireless users and encrypting wireless data.
IEEE 802.1x/RADIUS. IEEE 802.1x Port-Based Network Access Control and RADIUS
(Remote Authentication Dial-In User Service) settings for better wireless security.
(Remote Authentication Dial-In User Service) settings for better wireless security.
z
Advanced. Advanced settings of the AP.
Packet Filters. Ethernet Type Filters, IP Protocol Filters, and TCP/UDP Port Filters set-
tings.
tings.
Management. UPnP, System Log, and SNMP settings.
3.1.2. Save, Save & Restart, and Cancel Commands
Fig. 13. Save, Save & Restart, and Cancel.
At the bottom of each page that contains settings you can configure, there are up to three but-
tons—Save, Save & Restart, and Cancel. Clicking Save stores the settings changes to the memory of
the AP and brings you back to the start page. Clicking Save & Restart stores the settings changes to
the memory of the AP and restarts the AP immediately for the settings changes to take effect. Click-
ing Cancel discards any settings changes and brings you back to the start page.
tons—Save, Save & Restart, and Cancel. Clicking Save stores the settings changes to the memory of
the AP and brings you back to the start page. Clicking Save & Restart stores the settings changes to
the memory of the AP and restarts the AP immediately for the settings changes to take effect. Click-
ing Cancel discards any settings changes and brings you back to the start page.
If you click Save, the start page will reflect the fact that the configuration settings have been changed
by showing two buttons—Restart and Cancel. In addition, changes are highlighted in
by showing two buttons—Restart and Cancel. In addition, changes are highlighted in
red
. Clicking
Cancel discards all the changes. Clicking Restart restarts the AP for the settings changes to take ef-
fect.
fect.