Справочник Пользователя для Interepoch Technology Inc. IWE3000T

 

 

 

Fig. 2. Connecting a managing computer and a DRBAP via Ethernet. 

You can use either a cross-over Ethernet cable (included in the package) or a switch/hub with 2 nor-
mal Ethernet cables. 

One connector of the Ethernet cable must be plugged into the LAN/CONFIG Ethernet jack 

of the DRBAP for configuration. 

Use the Windows Network Control Panel Applet to change the TCP/IP settings of the managing 
computer, so that the IP address of the computer and the IP address of the DRBAP are in the same IP 
subnet. Set the IP address of the computer to 192.168.0.xxx (the default IP address of a DRBAP is 
192.168.0.1) and the subnet mask to 255.255.255.0. 

 For some versions of Windows, the computer needs to be restarted for the changes of TCP/IP 

settings to take effect. 

After you have connected the managing computer and the DRBAP via Ethernet, you can install 

Wireless Network Manager on the managing computer and use it to configure the DRBAP without 
being concerned about the TCP/IP settings of the managing computer. Refer to the on-line help of 
Wireless Network Manager for more information. 

After the IP addressing issue is resolved, launch a Web browser on the managing computer. Then, go 
to “http://192.168.0.1” to access the Web-based Network Manager start page. 

 For maintenance configuration of a DRBAP, the DRBAP can be reached by its host name using 

a Web browser. For example, if the DRBAP is named “DRBAP”, you can use the URL 
“http://DRBAP” to access the Web-based Network Manager of the DRBAP. 

Before the start page is shown, you will be prompted to enter the user name and password to gain the 

 

7