Справочник Пользователя для Interepoch Technology Inc. IWE3000T

 

Go to the IEEE 802.11, Communication section to configure IEEE 802.11g-related communication 
settings, including Regulatory Domain, Channel Number, Network Name (SSID), and Bridge Links, 
for both WLAN interfaces, depending on their interface types. No matter the type of a WLAN inter-
face is AP or LAN-to-LAN bridge, Regulatory Domain, Channel Number, and Network Name have 
to be configured. 

The number of available RF channels depends on local regulations; therefore you have to choose an 
appropriate regulatory domain to comply with local regulations. For two wireless devices to com-
municate with each other, they must be set to identical SSID (Service Set IDentifier). 

 

Fig. 10. Basic IEEE 802.11g communication settings. 

For a LAN-to-LAN bridge interface, also set the MAC address of each peer bridge according to your 
planned network topology. Specify an MAC address, and then select its corresponding checkbox. 

 

Fig. 11. Bridge links settings. 

When you are finished, click Save at the bottom of this page, and then you are brought back to the 
start page. 

Plan your wireless network and draw a diagram, so that you know how a DRBAP is connected 

to other peer bridges and can therefore set the bridge links settings correctly. 

Plan your wireless network and draw a diagram, so that you know how a bridge is connected to 

other peer bridges by WDS. See the following figure for an example network-planning diagram. 

 

11