Справочник Пользователя для Interepoch Technology Inc. IWE3200

 

 

37

 

Fig. 56. TCP/IP settings for Router with a PPPoE-Based DSL/Cable Connection mode. 

 
If the IWE3200 was set to be in Router with a PPPoE-Based DSL/Cable Connection mode, two IP 
addresses are needed—one for the Ethernet LAN interface and the other for the WAN interface. The 
LAN IP address must be set manually to a private IP address, say 192.168.0.xxx. The default LAN IP 
address is 192.168.0.1 and the default subnet mask is 255.255.255.0. In most cases, these default set-
tings need no change. 

As for the WAN IP address, it is obtained automatically by PPPoE from the ISP. Consult your ISP for 
the correct User name, Password, and Service name settings. 

The Trigger mode setting specifies the way a PPPoE connection is established. Your PPPoE connec-
tion can be established and torn down manually (Manual) by clicking the Connect and Disconnect 
buttons on the Start page, respectively. Or you can choose to let the device automatically (Auto) es-
tablish a PPPoE connection at bootup time. In Auto mode, if the connection is disrupted, the device 
will try to re-establish the broken connection automatically. 

Custom MAC Address of WAN Interface enables you to change the MAC address of the Ethernet 
WAN interface. Therefore, if the ISP-provided DSL or cable modem works only with the 
ISP-provided Ethernet card for a computer, the WAN interface of the Router can mimic the 
ISP-provided Ethernet card by changing its MAC address to the Ethernet card’s MAC address.