Test Setup Photos для SystemBase Co. Ltd. SG-1010WALL
SerialGate User Guide
18
Power connector: for connection of DC9~30V adapter cable
Terminal block power connector: for connection of terminal block power cable
Reset button: SerialGate reboots if this button is pressed for less than 3 seconds. If
pressed for longer than 3 seconds, SerialGate will restore its factory default settings.
LED: Operation status of SerialGate. Next section describes the meaning of each LED
display status.
LAN port: 8-pin RJ45 jack connects SerialGate to networking devices such as Ethernet
card, hub, and router.
Serial: RJ-45 socket for serial ports (RS-232, or Combo(RS-422/RS-485))
SerialGate-1010/232 & Combo RJ-45 Model LED / RESET
LED
Status
Meaning
PWR
(Red)
On
Power supplied to the device
Off
No power supplied to the device
LAN
(Green)
Off
No active network connection
On
Network activated
RDY
(Red)
Blink
Normal operation
On
System Booting
Off
System Error
RS422
On
Serial port set to RS422 mode (Combo model)
RS485
On
Serial port set to RS485 mode (Combo model)
Serial Tx/Rx
Green Blink
Serial data transmitted
Orange Blink
Serial data received
LAN Port
(Left Green)
On
100baseT connection detected & LAN data tran
sferred
Off
10baseT connection detected & LAN data trans
ferred
LAN Port
On
Network connected