Справочник Пользователя для SystemBase Co. Ltd. WCS232V4
D.2.2. Response Message
AT response messages from the WCS-232 may affect the host system unexpectedly. Do not use WCS-232 If
your applications cannot allow for this wireless time delay.
AT response messages from the WCS-232 may affect the host system unexpectedly. Do not use WCS-232 If
your applications cannot allow for this wireless time delay.
D.3. Transmission Delay
D.3.1. RF Processing Delay
It takes 30msec approximately for a WCS-232 to complete a data transmission to the other Bluetooth device.
This time delay cannot be reduced and may enlarge as the RF transmission environment becomes worse. Do not
use WCS-232 If your applications cannot allow for this time delay.
D.3.1. RF Processing Delay
It takes 30msec approximately for a WCS-232 to complete a data transmission to the other Bluetooth device.
This time delay cannot be reduced and may enlarge as the RF transmission environment becomes worse. Do not
use WCS-232 If your applications cannot allow for this time delay.
D.3.2. RF Transmission Environment
If there are many Bluetooth devices working in a small area and/or the RF communication distance is too great
and/or there are some obstacles affecting RF performance, the WCS-232 repeats the transmission packet by
packet due to interferences and/or low RF performance. This may lead to increased data transmission time
delays.
If there are many Bluetooth devices working in a small area and/or the RF communication distance is too great
and/or there are some obstacles affecting RF performance, the WCS-232 repeats the transmission packet by
packet due to interferences and/or low RF performance. This may lead to increased data transmission time
delays.
FCC Information to User
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is con-nected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution
Modifications not expressly approved by the party responsible for compliance could void the user
’s authority to
operate the equipment.
FCC Compliance Information : This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation
RF Exposure Statement :
The equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This
device and its antenna must not be co-located or operation in conjunction with any other antenna or transmitter.
device and its antenna must not be co-located or operation in conjunction with any other antenna or transmitter.