Справочник Пользователя для RadioFrame Networks Inc MCSERIESHP10
MC-Series High-Power System
Introduction
998--01 Rev X1
RadioFrame Networks, Inc.
CONFIDENTIAL AND PROPRIETARY 11
• Place FRUs only on an anti-static mat when removed from the system. The
conductive surface must be connected to ground through 100 kΩ.
• Do not use non-conductive material for packaging FRUs for shipment or storage.
Wrap all FRUs with anti-static (conductive) material. Replacement FRUs shipped
from the factory are packaged in a conductive material.
from the factory are packaged in a conductive material.
• If possible, retain all original packing material for future use.
1.2.2 Safety Warnings
1.2.2.1 Safety
Warnings
per Rack Mount Instructions
The following or similar rack-mount instructions are included with the installation
instructions:
instructions:
1
Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly,
the operating ambient temperature of the rack environment may be greater than
room ambient. Therefore, consideration should be given to installing the
the operating ambient temperature of the rack environment may be greater than
room ambient. Therefore, consideration should be given to installing the
Warning!
Use extreme caution when wearing a conductive wrist strap near sources of high
voltage. The low impedance provided by the wrist strap also increases the danger
of lethal shock should accidental contact with high voltage sources occur.
voltage. The low impedance provided by the wrist strap also increases the danger
of lethal shock should accidental contact with high voltage sources occur.
Warning!
Use extreme caution when wearing a conductive wrist strap near sources of high
voltage. The low impedance provided by the wrist strap also increases the danger
of lethal shock should accidental contact with high voltage sources occur.
voltage. The low impedance provided by the wrist strap also increases the danger
of lethal shock should accidental contact with high voltage sources occur.
Warning!
Ultimate disposal of this product should be handled according to all national laws
and regulations.
and regulations.
Warning!
The user is cautioned that changes or modifications made to the equipment that
are not expressly approved by the party responsible for compliance, could void
the user’s authority to operate the equipment.
are not expressly approved by the party responsible for compliance, could void
the user’s authority to operate the equipment.
Warning!
To ensure FCC compliance of this equipment, it is the user’s responsibility to
obtain and use only shielded and grounded interface cables.
obtain and use only shielded and grounded interface cables.
Warning!
FCC RF Exposure Compliance: FCC RF exposure compliance must be
addressed at the time of licensing, as required by the responsible FCC Bureau(s),
including antenna co-location requirements of §1.1307(b)(3). The applicable
exposure limits, to demonstrate compliance, are specified in FCC Part 1.1310.
Additionally, the installer of the antenna to be used with this transmitter may be
required to perform an MPE evaluation and an Environmental Assessment (EA)
of the location at the time of licensing per CFR 47 Part 1.1307. Fixed mounted
antenna(s) that are co-located with other antenna(s) must satisfy the co-location
requirements of Part 1.1307 for satisfying RF exposure compliance
addressed at the time of licensing, as required by the responsible FCC Bureau(s),
including antenna co-location requirements of §1.1307(b)(3). The applicable
exposure limits, to demonstrate compliance, are specified in FCC Part 1.1310.
Additionally, the installer of the antenna to be used with this transmitter may be
required to perform an MPE evaluation and an Environmental Assessment (EA)
of the location at the time of licensing per CFR 47 Part 1.1307. Fixed mounted
antenna(s) that are co-located with other antenna(s) must satisfy the co-location
requirements of Part 1.1307 for satisfying RF exposure compliance