Справочник Пользователя для GE Lighting WIT100

Wireless Integrated Thread Sensor

•  Turn power off before inspection, installation or removal

•  Follow all relevant IEC or UL instructions and local building codes

In case of Digital bus miswiring mains can present on 
the device. Make sure all electricity switched of before 
inspection.

Read these instructions completely and 
carefully.

To ensure the product warranty is valid, please ensure all installation instructions and environmental conditions for storage and operation are 
complied with.
Only  GE trained contractors can install the product. 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful 
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device complies with Industry Canada license exempt RSS standards.  Operation is subject to the following two conditions:  
• This device may not cause harmful interference, and  
• This device must accept any interference received, including interference that may cause undesired operation.

Cet appareil est conforme aux normes RSS exemptées de licence de Industrie Canada.  
Son fonctionnement est soumis aux deux conditions suivantes:
• Cet appareil ne doit pas provoquer d'interférences et  
• Cet appareil doit accepter toute interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.

To satisfy FCC/ISED RF exposure requirements a separation distance of 20 cm or more must be maintained between the antenna of this device 
and persons during operation. Operation at closer than 20cm is not permitted

Pour être conforme aux limites d’exposition aux ondes RF des normes FCC/ISED, une distance de séparation d’au moins 20 cm doit être main-
tenue entre l’antenne de cet appareil et toute personne pendant son opération.  Mettre en opération cet appareil a une distance plus rappro-
chée que 20 cm n’est pas permis.