Справочник Пользователя для IKUSI ELECTRONICA S.L. RAD-TS
7.3 Preventive maintenance
A few simple checks can bring to light certain defects which can later be the cause of
subsequent break-downs and which can be readily rectified. We recommend the following
checks to be made from time to time:
Transmitter:
Check the transmitter’s closing screws to make sure they are securely tightened.
Check the rubber protection seals on the transmitter’s command buttons from time to
Check the rubber protection seals on the transmitter’s command buttons from time to
time. Replace them if they are found to have deteriorated. This will protect the unit’s
watertightness.
watertightness.
Keep the battery contacts clean.
Receiver:
Check to make sure the cable fixture screws are tight.
Check the contacts on the fuses and the fuse-holders.
Check the contacts on the fuses and the fuse-holders.
Battery charger and batteries:
Keep all contacts clean.
7.4 Locating Break-downs
The transmitter and receiver both have status monitoring LEDs which help to identify
irregularities. The most common signals are contained in the tables below:
7.4.1 TRANSMITTER
LED MEANS
Green double flashing
Transmitter ready for start-up
Solid green
Transmitter transmitting normally
Red flashing
Battery level low
Red double flashing
Transmitter cannot start up because a manoeuvre
command is present
command is present
Solid red
Transmitter failure
RADS11 and RADF13 Users Manual ver0.4a.doc
KCI Hoists Corp. reserves the right to modify this information without prior notification.
KCI Hoists Corp. reserves the right to modify this information without prior notification.
Page 19 of 23