Справочник Пользователя для Wilson Electronics LLC 273201
3
Contact Wilson Electronics’s Technical Support Team with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com Mon.- Fri. Hours: 7am to 6 pm MST.
4
Place the Low-Profile Antenna on the
side of the driver’s seat for maximum
performance .
Install the Low-Profile Antenna at least eight
Install the Low-Profile Antenna at least eight
inches, but not more than 12 inches, from
where the cellular device will be used .
Install the Low-Profile Antenna at the same
Install the Low-Profile Antenna at the same
angle as the cell phone when held in use, or
place next to the laptop’s cellular data card .
This will maximize the signal strength .
For a more professional looking installation,
For a more professional looking installation,
the Low-Profile Antenna may be slid under
the seat cover or upholstery, high on the
driver’s seat .
Warning: Do not install the low-profile
antenna within four inches of metal .
(Metal found inside the vehicle’s seat will
not affect the antenna’s performance .)
Signal Booster
Low-profile
Antenna
Installing the Low-Profile Antenna
Installing a Wilson Electronics Signal Booster
Warning: The Inside Antenna must be
installed with a separation of at least eight
inches from all persons and must not
be located in conjunction with any other
antenna or Signal Booster .
Warning: Do not plug in the DC power
supply until the Outside and Inside
Antenna cables are attached to the Signal
Booster .
Run the cable from the Outside Antenna and
attach it to the connector labeled “Outside
Antenna” on the Signal Booster .
Attach the Low-Profile Antenna cable to the
Attach the Low-Profile Antenna cable to the
connector labeled “Inside Antenna” on the
Signal Booster .
!
!
!
Select a location to install the Signal Booster that is away from excessive heat, direct
sunlight, moisture and that has proper ventilation .
NOTE: The aluminum casing of a Wilson Signal Booster will adjust very quickly to the
ambient temperature of its environment. For example, in the summer, when the inside
of a car can reach 140 degrees Fahrenheit, the Signal Booster temperature may be 150
degrees or higher. The casing will be hot to the touch, similar to a metal door handle or a
steering wheel. Such high temperatures will not damage the Signal Booster, nor do they
pose a fire risk to the vehicle. As recommended in these instructions, install the Signal
Booster in a location with adequate ventilation, such as under the seat or under the
dashboard. Keep the area free of items that could block air flow to the Signal Booster.