Справочник Пользователя для Wilson Electronics LLC 273470

Select a location to install the Signal Booster that is away from 

1 . 

excessive heat, direct sunlight, moisture and has proper ventilation . Do 

not place the Signal Booster in an air-tight enclosure . 
Select a location on the roof of the building to install the Outside Antenna . 

2 . 

Use a cell phone in test mode to find the strongest signal from the cell tower . 

Refer to page 7 . Visit www.WilsonElectronics.com to find the test mode 

function for your particular cell phone . 
Run the Outside Antenna cable to the Signal Booster and attach it to the 

3 . 

connector labeled “Outside Antenna” on the Signal Booster . Refer to page 

8 for more information on running cable . Lightning Surge Protection is 

recommended for all in-building installations refer to page 6 .
Select a location for the Inside Antenna, preferably in the center of 

4 . 

where the signal needs to be amplified . A minimum separation distance 

of 

20 vertical feet (within the null zone) or 50 horizontal feet is 

necessary for proper operation . If the inside coverage is not sufficient 

you may need as much as 

75 feet of horizontal separation (refer to 

installation diagram on pages 3 & 4) . Run the Inside Antenna cable to the 

Signal Booster and attach it to the connector labeled “Inside Antenna” on 

the Signal Booster .
Before powering up the Signal Booster, verify that both the Outside 

5 . 

Antenna and the Inside Antenna are connected and check that all 

connections are tight . Refer to page 9 . 

the connectors in so as not to bend the center pins on the connectors. 
If lights are not green, please refer to pages 13 & 14 .

6 . 

See Installation Diagram on page 3 & 4 . Contact Wilson Electronics 

Technical Support Team with any questions at 866-294-1660 .

Connecting the Signal Booster directly to a cell phone with  

 

use of an adapter will damage the cell phone and/or the  

 

Signal Booster .

It is very important to power your Signal Booster using a 

•

surge protected AC Power Strip with at least a 

Failure to do this will void your warranty in the 

•

event of a 

power surge or lightning strike .