Справочник Пользователя для Remington Security Camera Inc. CAM02420
5. Operation
Basic operation :
1.
Make sure the ON/OFF switch is in the OFF position before connection
2.
Connect the supplied AC adapter output to the DC input jack at the rear of the receiver monitor.
3.
Select a channel 1 – 4 on your transmitter
4.
Switch on the Monitor and transmitter camera
5.
Search the channel 1 – 4 on the monitor using the channel selector switch. , you should see the
Picture on the receiver.
Picture on the receiver.
6.
Select another channel on transmitter and receiver if necessary for better picture quality.
7.
Volume control – adjust the knob for desired volume level.
If you don’t want to h ave the audio, press down Mute button to disable the
sound output.
sound output.
8.
Bright and Contrast control – If the picture is too bright or too dark, adjust the bright and contrast
controls to get the best picture quality.
controls to get the best picture quality.
9.
Using Audio Mute button to disable the speaker .
10.
Adjust the antenna as necessary
Select no. of activate channel
The Monitor is setup as 4 active channel when first power up. That is, you can select either ch 1, 2, 3 or 4.
In Auto mode the channel will scan through Ch 1 to 4.
However, if you have only three transmitters ( 3 channel ) in the system, you don’t need to see channel 4.
Then you can adjust the no. of active channel to 3.
In Auto mode the channel will scan through Ch 1 to 4.
However, if you have only three transmitters ( 3 channel ) in the system, you don’t need to see channel 4.
Then you can adjust the no. of active channel to 3.
Press and hold the AUTO/MANUAL button to select the no. of channel that is activate. When you press
and hold the Auto/Manual button for 2 sec , all 4 LED will lit and if you release at that moment, all 4
channel will be activate. If you continue to hold the button, Channel 4 LED will be off and the remain 3
LEDs on. If you release the button at that moment,only Ch 1- 3 will be activate in the scanning system. If
you continue to hold the button, Ch3 LED will off and only CH 1 and Ch2 LED will be on. If you release at
that moment, only Ch1 and 2 will be activate. If you continue to hold the button, then all four LED will be
on again and repeat the procedure.
and hold the Auto/Manual button for 2 sec , all 4 LED will lit and if you release at that moment, all 4
channel will be activate. If you continue to hold the button, Channel 4 LED will be off and the remain 3
LEDs on. If you release the button at that moment,only Ch 1- 3 will be activate in the scanning system. If
you continue to hold the button, Ch3 LED will off and only CH 1 and Ch2 LED will be on. If you release at
that moment, only Ch1 and 2 will be activate. If you continue to hold the button, then all four LED will be
on again and repeat the procedure.
Select Automatic scanning or Manual scanning