Справочник Пользователя для Xsilogy Inc. 0920
FCC Compliance Information
Introduction
1-2
Preliminary Release X1
WARNING: Improper handling of batteries can cause
serious injury. Refer to the battery manufacturer’s installation
and service instructions before installing BattGuard
Telesensors.
serious injury. Refer to the battery manufacturer’s installation
and service instructions before installing BattGuard
Telesensors.
Notes and Warnings
Note
Helpful Information – A note conveys additional information
that may be helpful in completing a task.
that may be helpful in completing a task.
WARNING – Personal Injury or Severe Equipment Damage
– This special note warns you of a potentially hazardous
situation in which there may be possibility of personal injury
or severe equipment damage.
– This special note warns you of a potentially hazardous
situation in which there may be possibility of personal injury
or severe equipment damage.
FCC Compliance Information
Radio Frequency Interference Requirements – USA
WARNING A minimum separation distance of 20 cm.(6
inches) must be maintained between the radiating element
of the transmitter and nearby persons in order to ensure
compliance with FCC rules for rf exposure. This transmitter
must not be co-located with other transmitters or antenna
inches) must be maintained between the radiating element
of the transmitter and nearby persons in order to ensure
compliance with FCC rules for rf exposure. This transmitter
must not be co-located with other transmitters or antenna
This device uses, generates, and radiates radio frequency energy. The radio
frequency energy produced by this device is well below the maximum
exposure allowed by the Federal Communications (FCC).
frequency energy produced by this device is well below the maximum
exposure allowed by the Federal Communications (FCC).
This device complies with the limits for a class B digital device pursuant
to Part 15 subpart C of the FCC Rules and Regulations. Operation is
subject to the following two conditions:
to Part 15 subpart C of the FCC Rules and Regulations. Operation is
subject to the following two conditions:
1. This device must not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired operation.
The FCC limits are designed to provide reasonable protection against
harmful interference when the equipment is installed and used in
accordance with the instruction manual and operated in a commercial
harmful interference when the equipment is installed and used in
accordance with the instruction manual and operated in a commercial