Справочник Пользователя для Microsoft Corporation RA-4
Charging the battery
1. Connect the charger to an AC wall outlet.
2. Connect the power cord to the bottom of the device.
bar starts scrolling on both displays. If the battery is totally discharged, it may take a few minutes before the charging
indicator is shown. The device can be used while charging.
indicator is shown. The device can be used while charging.
3. When the battery is fully charged, the bar stops scrolling. Disconnect the charger from the device and then from the AC
outlet.
When the battery charge level is too low for operation, the device switches itself off. If the cover phone switches off, the
communicator interface may still be active for a while.
communicator interface may still be active for a while.
Switching the device on and off
To switch the cover phone on, press and hold the power key. The power key switches only the cover phone
on, it does not affect the communicator interface, which switches itself on when you open the cover. The
communicator interface is switched completely on and off by inserting and removing the battery. The
communicator interface can be used without the phone functions when a SIM card is not inserted or when
the
on, it does not affect the communicator interface, which switches itself on when you open the cover. The
communicator interface is switched completely on and off by inserting and removing the battery. The
communicator interface can be used without the phone functions when a SIM card is not inserted or when
the
Offline
profile is selected.
If the device asks for a PIN or security code, enter the code, and press
OK
.
To switch the cover phone off, press and hold the power key. To switch the communicator interface completely off, remove
the battery.
the battery.
Tip: When you switch the phone on, it may recognize the SIM card provider and configure the correct text message,
multimedia message, and GPRS settings automatically. If not, contact your service provider for the correct settings.
multimedia message, and GPRS settings automatically. If not, contact your service provider for the correct settings.
The communicator interface starts up first after the battery is inserted. You cannot switch on the cover phone immediately
after the battery has been inserted, you must wait until the communicator interface has started.
after the battery has been inserted, you must wait until the communicator interface has started.
Tip: If you have removed the battery and quickly reinserted it, you may need to press the power key once before
the communicator interface starts up.
the communicator interface starts up.
Antenna
Your device has an internal antenna.
Note: As with any other radio transmitting device, do not touch the antenna unnecessarily when the
device is switched on. Contact with the antenna affects call quality and may cause the device to operate
at a higher power level than otherwise needed. Avoiding contact with the antenna area when
operating the device optimises the antenna performance and the battery life.
device is switched on. Contact with the antenna affects call quality and may cause the device to operate
at a higher power level than otherwise needed. Avoiding contact with the antenna area when
operating the device optimises the antenna performance and the battery life.
The picture shows the normal use of the device at the ear for voice calls.
{unresolved reference to ID 'GUID1E9749B7A32811D8A467000BDB6BA40A'}
{unresolved reference to ID 'ref_id_from_getting_started'}
Access codes
The device uses several access codes to protect against unauthorized use of the device and the SIM card.
You need the following access codes:
G e t t i n g s t a r t e d
Copyright © 2005 Nokia. All Rights Reserved.
9