Справочник Пользователя для Dongguan ShengYu Elctronic Technology CO. LTD SA-W989
1.9 Bluetooth Disconnect: When the Bluetooth is in the mode of disconnected, the notification
will be “not connection” If you disconnect your Bluetooth device with the speaker, the LED light
will start twinkling quickly, it means the speaker is in the pairing mode. If there is no device to be
paired with the speaker; If you disconnect your phone and speaker, but forget to close our
Bluetooth speaker, it will turn off automaticly 5 minutes later. If your phone is connected with the
speaker, while you have a call comes in, and you answering the call, you leave away from the
speaker, since the distance will cause the speaker and your phone disconnected, you will hear the
notification ”not connection” from our speaker, So we suggest you need to answer the call closed
to the Bluetooth speaker. Another situation, if your audio device is taken away from our bluetooth
speaker while it is connected, it will be disconnected since the distance between them, you also
can hear ”not connection”. once you close to the speaker it will connect with the speaker
automatically and voice out ”paired”. Then you can play your music again.
2.0 NFC operations: Please check the NFC mark on the silicone cover, near Field communication,
is as set of standard for smartphone and this speaker to establish Bluetooth radio communication
with each other by touching them together or bringing them into close proximity, usually no more
than a few centimeters. You should always pay attention to your phone’s screen to focus on the
steps to finish the connecting with our bluetooth speaker.
‐You can pair up the device by NFC triggering.
‐Make sure your music device or mobile phone do have the NFC function. Please refer to your
music device or mobile phone instruction manual for detail.
‐Make sure the NFC function and S Beam function are both enabled at your music device or mobile
phone. Please refer to your music device or mobile phone instructional manual for detail.
‐Switch on our Bluetooth speaker.
‐Place the music device or mobile phone on our bluetooth speaker where the NFC located. The
music device or mobile phone will prompt a new Bluetooth device is found and would you like to
pair it up. Pick up the music device or the mobile phone(You are strongly suggested to pick up the
music device before accepting to pairing up in order to reduce the signal interference).Now you
can press on the music device or mobile phone to accept pairing up with the founded bluetooth
device. Once the device is connected with our bluetooth speaker, it will voice out “paired” Repeat
the above process again to unpair our bluetooth speaker.
Important: For some smartphones, please active the NFC function(subjects to phone’s own
setting)and Bluetooth function of your smartphone at the same time.
（NFC Only receiver function）
2.1 Button function: The speaker with the function likes volume control, songs tracking,
play/pause ect, handsfree, all the functions will be come ture by operating the buttons on the
silicone cover.
2.1.1 ON/OFF button on the speaker, (see Diagram 1 below).
2.1.2 VOL‐/BWD button function (see Diagram 1 below): Long press the button is control the
volume“‐“ (VOL‐/FWD) ,short press the button is for the songs backward and forward.
2.1.3 VOL+/FWD button function (see Diagram 1 below): To increase volume press “+”
(VOL+/FWD) button and hold, to go to next song press the button shortly.
2.1.4 PLAY/PAUSEbutton function(see Diagram 1 below): When playing music, the Play/Pause
can control playing the audio source, short press Play/Pause button to pause or play music.
2.2 Micro USB Charging/Aux‐in port: These ports are on the top of the unit, You can charge the
built‐in
Li ‐Ion battery via the micro USB port, you can see Red LED light will be lighten up. If you
connect your device and the speaker via the audio cable, the speaker can play music directly.