Справочник Пользователя для CipherLab Co. Ltd. 1664
50
Enter Setup
1664 Barcode Scanner
User Guide
1.18 HARDWARE RESET
1.18.1 RESTORE SYSTEM DEFAULTS
Instead of having the scanner read “Restore System Defaults” barcode, use key
combination, as described below, to restore system defaults during operation.
combination, as described below, to restore system defaults during operation.
1) Hold down the [Power/Delete] key.
2) When the scanner responds with two short beeps (high tone), press the [Trigger] key
2) When the scanner responds with two short beeps (high tone), press the [Trigger] key
for about 5 seconds. The scanner LED indicator becomes solid red for a while and
then goes off.
then goes off.
3) When the scanner responds with a long beep (high tone), release the keys. Its LED
indicator becomes solid red and goes off quickly.
Note: The scanner will restart itself automatically.
1.18.2 RESET CONNECTION
When the output interface is Bluetooth
®
HID or Bluetooth
®
SPP Master, the scanner will
attempt to maintain an established connection. To stop such re-connection, it may need
to have the scanner read “Reset Connection” or “Restore System Defaults” barcode to
to have the scanner read “Reset Connection” or “Restore System Defaults” barcode to
clear the current connection record. Alternatively, use key combination as described
below to reset connection during operation.
below to reset connection during operation.
1) Hold down the [Trigger] key, and then press the [Power/Delete] key for at least 5
seconds.
2) The scanner will respond with two short beeps (high tone). Wait for a while until the
scanner responds with a long beep (high tone), release the keys.
Note: After reset connection by hardware, the scanner will not restart itself automatically.
It will resume to its previous operation except no connection.