Справочник Пользователя для Inside Secure M2502G
Hand'IT
-2G -Preliminary Datasheet
DS - 9
Version 1.1
CHAPTER 2
HAND'IT-2G CONNECTION
This chapter describes :
! How to power the coupler
! How to communicate with the coupler
! How to communicate with the coupler
Physical Description
The host is connected to the Compact Flash Hand’IT 2G using a standard 50pin
connector.
The host must be equiped with a CF+ type 1 or 2 slot.
Refer to the host user manual for the Compact Flash card insertion.
connector.
The host must be equiped with a CF+ type 1 or 2 slot.
Refer to the host user manual for the Compact Flash card insertion.
Electrical Description
The HandIT 2G acts as a standard PC Card ATA using I/O Mode.
Refer to PC Card standards for details.
Refer to PC Card standards for details.
Power supply
CHARACTERISTICS
To power up the coupler, just insert the device into a CF type I or II slot.
Note that opening the associated COM port will power on the device and closing will
Power it off.
Refer to the host operating system for more details.
Note that opening the associated COM port will power on the device and closing will
Power it off.
Refer to the host operating system for more details.
Description
M in.
Typical
M ax.
Unit
DC voltage
3,135
3,3
3,465
V
RF active current
50
TBD
mA
Idle Mode current
5
TBD
mA
Standby current
50
TBD
µA
Electrical characteristics