Справочник Пользователя для S-1 Corporation MOD10003
INTRODUCTION & INFORMATION
- 2 -
UWB Intrusion Detection Sensor – URX-P01
Information to the User
The UWB sensor is an ultra-wideband(UWB) module certified under FCC Part 15.519.
It’s use is subject to technical requirements for Hand Held UWB systems, in particular the
stipulation that the devices should only be used indoors. Users should note carefully the
following information:
It’s use is subject to technical requirements for Hand Held UWB systems, in particular the
stipulation that the devices should only be used indoors. Users should note carefully the
following information:
• This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Users should also carefully note the following information:
• CAUTION: Any changes or modifications made to the “UWB Sensor” which are not
expressly approved by the “S-1” could void the user’s authority to operate the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications, However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
reasonable protection against harmful interference in a residential installation This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications, However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
Is connected.
- Consult the dealer or an experienced radio/TV technician for help.
End Product Labeling:
• This transmitter module is authorized only for use in device where the antenna may be
installed such that 20 cm may be maintained between the antenna and users. The final end
product must be labeled in a visible area with the following: “Contains FCC ID:
Q54MOD10003”. The grantee's FCC ID can be used only when all FCC compliance
requirements are met.
product must be labeled in a visible area with the following: “Contains FCC ID:
Q54MOD10003”. The grantee's FCC ID can be used only when all FCC compliance
requirements are met.
Manual Information to the End User:
• The OEM integrator has to be aware not to provide information to the end user regarding
how to install or remove this RF module in the user’s manual of the end product which
integrates this module. The end user manual shall include all required regulatory
information/warning as show in this manual.
integrates this module. The end user manual shall include all required regulatory
information/warning as show in this manual.