Справочник Пользователя для Canfield Industries Inc. RVIM1
Step 6) After the compressor has shut off, (approximately 30 seconds)
push the green Auto Start button on the Rvibrake control panel.
The Rvibrake actuator will automatically push on the brake pedal 5
times accomplishing 2 different tasks:
1) Remove any vacuum stored in the towed vehicles braking reservoir.
2) Automatically position the Rvibrake housing firmly against the seat
pan of the towed vehicle. (Fig. 5)
Warning: Anytime the towed vehicle’s engine is started, (to charge
the battery or run through the gears etc.) you must push the Auto
Start button on the Rvibrake control panel after shutting off the
towed vehicle’s engine to remove the vacuum stored in the towed
vehicle’s braking reservoir. Failure to drain the vacuum will result
in tire damage or excessive brake wear.
2) Automatically position the Rvibrake housing firmly against the seat
pan of the towed vehicle. (Fig. 5)
Warning: Anytime the towed vehicle’s engine is started, (to charge
the battery or run through the gears etc.) you must push the Auto
Start button on the Rvibrake control panel after shutting off the
towed vehicle’s engine to remove the vacuum stored in the towed
vehicle’s braking reservoir. Failure to drain the vacuum will result
in tire damage or excessive brake wear.
Step 7) Raise the Wireless antenna so that it is pointing up. When stowing
the Rvibrake lower the antenna to the horizontal positions so that
the antenna will not get damaged. (Fig. 6)
Rvibrake Operating Instructions
Vacuum vs. Active Brakes: The Rvibrake is designed to work with
both Vacuum assist and Active Brake towed vehicles. Vacuum
assist vehicles use vacuum to boost the pressure when braking
assist vehicles use vacuum to boost the pressure when braking
while Active brake vehicles have electrical systems to assist in
braking. To determine what type of braking assist your towed
vehicle has, refer to your vehicles Owner’s manual or call your
local automobile dealer. (Fig. 1)
Failure to properly set the vehicle selection to the proper setting
may cause severe tire damage.
may cause severe tire damage.
Vacuum Brakes Operating Instructions
Step 1) Vehicle Selection (Vacuum): If your towed vehicle uses Vacuum
assist; press the Vehicle Selection button on the control panel until
the Vacuum LED is illuminated. Once the Vacuum LED is illuminated
continue to push the Vehicle Selection button until the type of
vehicle you are towing (i.e. Compact Car, Small SUV, Large SUV etc.)
is Illuminated. If you are towing a SUV always start in the Small SUV
setting first. (Fig. 2)
(Fig. 5)
(Fig. 6)
(Fig. 1)
(Fig. 2)