Справочник Пользователя для Mobile Action Technology Inc. 17H68R1

User Manual

Q-68HR

Q-Band

EN

Wear Q-68HR on your wrist

Charge your Q-68HR

Fasten Q-68HR with clasp

Change the wristband

Put on the wristband with the screen facing up and the band wrapped 

around your wrist. Slide one band through the loop of the other band, and 

align the clasp along the band to find the holes where best fit the clasps.

Squeeze both clasps into the holes on the wristband until you hear a 

click, indicating the band is securely fastened.

Note:  The watch band is replaceable and both side wearable/reversible.

Spread open both bands with the screen facing up, and press down the screen 

with your thumb until the core comes off the wristband.
Insert the core with screen facing up into the notch from below the wristband. 

Make sure the two tenons on each side of the core are securely fixed into the 

corresponding slots in the bands.

Important Notice: 

Failure to follow the instructions above might cause damage to the device.

1. 

2.

Reversible Wristband

Clasp

Core

Touch Button

Metallic contact for charging

Optical Sensor

To charge your Q-68HR, place it in the charging box at the 

other end of the USB cable. Close the box afterwards, and 

make sure the Q-68HR is securely covered. Plug the USB 

connector to either a PC or power adapter to start charging.