Справочник Пользователя для Craft House Corporation 7320249

 
 
 
 

1.        Twist the antennae into the top of the transmitter. 
2. 

Turn the vehicle & transmitter ON/OFF switch to the ON position. 

3. 

The first toggle on the left side on the transmitter will move the vehicle 
forward when pushed. The vehicle will move in reverse when the toggle is 
pulled back towards you. 

4. 

Push the middle toggle to start the hopping action. The car can hop while 
moving or while standing still. 

5. 

The last toggle on the right will steer the vehicle either left or right. 

 
 
NOTE 

-  You can control the vehicle at a longer distance by holding the transmitter 

higher with the antenna straight up. 

-  When the vehicle slows down or starts moving erratically, replace all dying 

batteries with fully charged batteries. 

 
OPERATING SAFETY RULES 
 
Select a SAFE place to operate your vehicle. Do not drive in the street. Avoid driving on 
sand or through puddles of water. These hazards can impair your performance. Check the 
surface ahead of you and watch for obstacles. The radio receiver in your vehicle and 
transmitter are sensitive instruments. Do not leave vehicle or transmitter near sources of 
HEAT or DIRECT SUNLIGHT for long periods of time. 
 
Avoid leaving vehicle or transmitter outside overnight. NIGHT DAMPNESS IS 
HARMFUL TO INTERIOR MECHANISM. 
 
 
RADIO INTERFERENCE 
 
Sometimes erratic behavior or loss of control of vehicle is the result of interference 
caused by high tension wires, high voltage transformers, certain types of buildings, 
concrete walls or narrow places where radio signals sent from your transmitter may be 
scattered thus making it difficult for your vehicle to receive a good radio signal. If you 
encounter this type of behavior or loss of control, change to a different location. 
 You will encounter interference if another radio controlled vehicle or CB radio is 
operating in the same vicinity on your same frequency.