Справочник Пользователя для Hewlett Packard Enterprise Company MST200DFS

| Installation Guide

Figure 11  Mounting the MST200 on a pole 

1. Begin by marking the screw points on the wall in the location you have selected.

a. Put the mounting bracket on the installation position against the wall.

b. Mark four expansion screw holes on the wall.

Figure 12  Position of the screw holes on the mounting bracket

2. Use a drill to create four holes on the four markings you created in the previous step. 

3. Install wall (masonry) anchors.

a. Insert a masonry anchor into each drilled hole.

b. Tap the flat end of the anchor with a rubber hammer until the anchor is flush with the wall surface.

4. Attach the mounting bracket to the wall.

a. Align the four holes in the mounting bracket with the anchors and insert four expansion screws 

through the installation holes into the anchors. 

b. Adjust the position of the mounting bracket and tighten the expansion screws. 

5. Fasten the positioning bracket onto the back of the MST200 using the five M6 x 12 bolts (with flat and 

spring washers). (There is screw thread in the screw hole of the mounting bracket, so nuts are not 
required).

6. Use the two M8 x 16 bolts (with flat washers and spring washers) to fasten the positioning bracket 

flanges to the mounting bracket flanges. 

Screw Hole