Справочник Пользователя для SendFar Technology Co. Ltd. OAP-04003

 

 

4

 
Step 1:

With the unit powered off, attach the dipole antenna to the antenna 

connector as shown in Figure 1.3. 
 
NOTE: Do not over-tighten; finger tight is sufficient. Position the antenna 
vertically for best omni-directional signal reception. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Figure 1.3. 

 
Before installing your WLAN system, we recommend that you test the 
Access Point using the dipole antenna included in your package. Once 
testing is completed, install your Access Point for use with the appropriate 
antenna for your application. 
 

 

 

5

 
Step 2: Attach the Console Port cable to the Serial Port. Attach the other 
cable end to the Serial Port on a PC running a terminal emulation program, 
and set the terminal to 115200 Baud, No-Parity, 8 data bits, 1 Stop bit, and 
ANSI compatible. 
NOTE: This connection is required for setting up initial configuration 
information. 
After configuration is completed, this cable may be removed until additional 
configuration is required via the Serial Port. 
 

Plug the female end of the power cord into the Inline Power Injector, 

and then plug the male end of the power cord into a power outlet or power 
strip. The Power LED on the front of the Inline Power Injector will light up. 
 
Step 4

Run the cross over Ethernet cable (included in your package) from 

Data Input Port (on the front of the Inline Power Injector) to the Ethernet Port 
on the PC we mentioned above. 
 
NOTE: This connection is required for setting up initial configuration 
information. After configuration is completed, this cable will be removed, and 
then you should run an Ethernet cable from Data Input Port (on the front of 
the Inline Power Injector) to the LAN connection (such as a hub or 
concentrator). 
 
Step 5

Plug the MIL-C-5015 style Ethernet connector into the Special 

Ethernet port on the back of the access point. 
 
Step 6

Plug the RJ-45 Ethernet connector (the other end of the Special 

Ethernet cable) into the Power & Data Output Port on the front of the Inline 
Power Injector. When the Access Point receives power over the Ethernet 
cable, the Access Point will start its boot sequence and the Active LED on 
the front of the Inline Power Injector will light up.